Abstract:Two kinds of konjac glucomannan (KGM), named aKGM and rKGM, were isolated from the tubers of Amorphophallus albus and rivieri respectively. The chemical-Structure and the rheological properties of aKGM and rKGM, synergism of KGM anti xanthan gum, as well

Abstract:In this paper, distinction of headspace and likens-Nickerson simultaneous distillation in the isolation and concentration of meat flavor and aroma components generated with maillard-reaction for GC analysis are studied.

Abstract:The refreshing preservation of fresh strawberry juice is studied in this paper. Three factors (temperature, preservative substance, pH)which influence the quality of strawberry juice in storage periods are discussed. The best technological conditions unde

Abstract:The effect of etherifying and cross-linking on starch is studied in this paper. The results obtained are as follows: By the reaction of corn starch with propylene oxide(PPO), its paste clarity, low-temperature stability are significantly improved; and pas

Abstract:In terms of the information, moisture content, temperature, quality, sealability and storage life of rice, this paper estimates small, middle, and high amount of pesticide.

Abstract:Three problems of surface hardening metal material by CW laser beam are discussed in this paper: method of increasing absorption capacity of machined surface, strengthening laser pattern arrangement in the machined surface, and relationship of hardening p

Abstract:In this paper, the relations between the parameters of the spiral wound paper tubes and between the diameter of the pulleys and the maximum outer diameter of the paper tubes have been studied. And the formulas for the length and working forces of the driv

Abstract:A new method of operating Z80-PIO without using interrupt. is introduced. Sample programs of I/O, emplpying both methods, with and without interrupt, for more satisfactory Z80-PIO operation are presented.

Abstract:Based on the mechanical potential of interlock machine and structure of interlock stitch, this article introduces some new methods ofproduct design by using needle-pulling, tucking and cam-changing. Thus, it is possible to reduce the density of interlock

Abstract:In this paper, statistical relationship between the represent(?) and the population is studied, and several properties of losefun(?) obtained.